Errors reported with Release 16.2

***********************************************************************;
* (C) COPYRIGHT 2006, COMPUTER MANAGEMENT SCIENCES, INC.               ;
* ALL RIGHTS RESERVED.                                                 ;
***********************************************************************;

This member contains a log of the errors which were discovered with
CPExpert Release 16.2, and acknowledges the user who discovered the
error.   Thanks for reporting the errors!

DATE       MODULE     ERROR DESCRIPTION

11/07/06   DASDXD1    Corrected RETAIN to retain only numeric variables.
                      Glenn Bowman (Wakefern Food Corp., NJ)

11/07/06   GENLOG     Corrected case where no rules were found in this
                      iteration of GENLOG, but rules existed from previous
                      analysis.  This case caused a SAS error in some
                      versions of SAS.
                      Paul Gordon (Bank of America, VA)

11/09/06   WLMMAIN    Correct XG78IO,XG78CF,and XG78VS specification
                      (incorrect when N_PLEX=Y and specific sysplex
                      selected).
                      James Barton (Veterans Administration, TX)

11/13/06   WLM032     Increased the array sizes from 20 to 99, to take care
                      of case where many served service classes were defined.
                      Markus Bansemir (HUK-Coburg, Germany)

11/13/06   WLMEVALI   Corrected macro testing for SYS1-SYS5.
                      Markus Bansemir (HUK-Coburg, Germany)

11/14/06   WMQGUIDE   Corrected WMQBODY specification when SAS ODS is used.
                      The original specification was missing a semi-colon.
                      Sam Knutson (GEICO, MD)

11/16/06   WMQEVAL    Removed WMQOFF1 (this was used in WMQGLBL and should
                      not be used in this module).
                      Sam Knutson (GEICO, MD)

11/16/06   WLMEVALP   Corrected code for WLM040 (applies only to MXG at present).
                      Kris Ferrier (State of Washington)

11/19/06   WMQSHAPE   Corrected logic that detects whether MQMCFMGR has observations
                      after selection criteria is applied and test for TYPE74ST.
                      Sam Knutson (GEICO, MD)

11/20/06   WLMEVALJ   Set SMF30xxx performance flags to N if MICS corresponding
                      variables not positive values.
                      Kris Ferrier (State of Washington)

11/20/06   DAS260     Corrected OUTDASD statement from above change.
                      Kris Ferrier (State of Washington)

12/11/06   WLM003     Removed incrementing POLCHG, since this was done
                      in WLMEVALS.
                      Ken Jones (Bell Aliant, Halifax, Canada)

12/14/06   CIC104     Set global switch for regions to indicate that CIC104 was
                      produced for a specific region (used when multiple regions are
                      analyzed in one pass of the evaluation code).
                      Paul Gordon (Bank of America, VA)

12/14/06   CIC108     Set global switch for regions to indicate that CIC108 was
                      produced for a specific region (used when multiple regions are
                      analyzed in one pass of the evaluation code).
                      Paul Gordon (Bank of America, VA)

12/14/06   CICEVALP   Added code to suppress Rule CIC104 for regions to which CIC104
                      did not apply, but multiple regions were analyzed in one pass.
                      Apply same code for CIC108 analysis.
                      Paul Gordon (Bank of America, VA)